well, after two months of having this thing, and after a few build fixes that needed new parts shipped out...I finally got it to run the cube code without the plastic.

the first time the wires went ablaze because I used the wrong size stereo wire. by the time I got to wiring the power supply, I forgot all about page 4's wire size instructions...



so, with our first test of the code run, I hope to try our first print on tuesday when the hair spray for the bed arrives. didn't get around to ordering it until the last minute of course.

here is hoping all goes well....I'm a little un sure if I am placing the filament in the right way though...