PEI Sheet for Bed Adhesion

[usarmyaircav]

I am totally impressed with the PEI sheet. I have mine attached with the high temp 3m double sided adhesive tape. No issues with prints sticking, every few prints or so, I also give it a light sanding with 2,000 grit sandpaper. I have been printing mine at 235 hotend, and 90 for the bed. If they get a 10x10 buildtak, I might have to try that sometime. correct me if I am wrong but they don't make that size yet.

[bstag]

I am totally impressed with the PEI sheet. I have mine attached with the high temp 3m double sided adhesive tape. No issues with prints sticking, every few prints or so, I also give it a light sanding with 2,000 grit sandpaper. I have been printing mine at 235 hotend, and 90 for the bed. If they get a 10x10 buildtak, I might have to try that sometime. correct me if I am wrong but they don't make that size yet.

Sure they do
http://www.amazon.com/BuildTak-Print...273608&sr=1-11

Make sure if any of you use it to not have the printer set to smush to much ever. The site covers it pretty well. you have to have the nozzle higher then normal or you end up with parts that could be very hard to remove. Also hot bed temps can be lower.