it warped)bottom right corner of the box is lifted off the bed) and delamination happens due to poor intra-layer adhesion and warping caused at different points during the printing process...

you can usually fix the layer adhesion by going up in hot end temps , Cura tends to extrude on the heavy side, so you can lessen the blobs by lowering your extrusion multiplier or the e-steps in the machine config.

as far as the warping, if you are printing in ABS, having the hotend fan blowing towards teh extruder causes lots of air to be blown towards the part and will cause warping, but also if the room you are printing in is cool and there is a draft of any sort it can also cause a warp out of nowhere.