Yes probe is retracted normall

When I run a job, probe is up
Starts to home.. X, Y are done and the carriage moves up Z, and then prob lowers and then Z lowers down until Z endstop is hit,
once Z enstop is engaged the 2nd time, Probe retracts immediately, bumping into the bed, and moving the entire gantry up a few mm,
then ABL sequence starts, goes to first positon, probe lowers again and starts taking measurements.. after the 9 readings.. during the last reading it retract up bumping endstop into the bed, shaking the carriage again vertically
and then it starts printing.

I will take a video to help explain the issue