New Owner Saying Hello

[N5QM]

Hello everyone! I am new to 3D printing and just received my Creator Pro today.

I have managed to get it assembled, done some test prints, and then gone on to print 3 or 4 other things to learn how things work.

Using the resources available here and on Youtube made it very easy to get up and running with Slic3r and GPX and I have thus far not even connected the printer to a computer, which seems odd to me, but very convenient.

I expect I will have many questions as time goes on, but thus far, I couldn't have asked for a better introduction into 3D printing. I must say the print quality is much better than I expected as well. Thanks again...

Robert

[jdg56]

Welcome to the 'club'. You'll find lots of good info here.

Cheers,

John

[N5QM]

Thank you John...

[LakeDuck]

Welcome! Post any questions no matter how simple they seem and post all information that you think other might benefit from, regardless of how trivial it may seem