You are correct. It is 5. Derp. I print at anywhere between 185 and 270. Not on the i3v however. I have not had the hexagon up that high yet. I am still not as confident with that hotend as I am...
Type: Posts; User: swirvbox
You are correct. It is 5. Derp. I print at anywhere between 185 and 270. Not on the i3v however. I have not had the hexagon up that high yet. I am still not as confident with that hotend as I am...
Brown is ground, red is +5v and orange is fruit. Refer to this chart
http://3dprintboard.com/attachment.php?attachmentid=5541&stc=1
You would pull the pins out of the 3 pin dupont connector and...
Not really. You use ethyl acetate. It is sold at your local hardware store as MEK substitute. Just look for MEK (they don't sell real MEK at most hardware stores anymore) and you will find it. It...
If you have your E-steps at 848 and extrusion multiplier at .88 then you don't have your E-steps right. 848 sounds really low to me. After calibration I get 911.2 for mine. Be sure that your...
I have auto bed tramming working on our Rumba. I used the most recent stock Marlin firmware. It has sections for the Rumba and all the latest toys. I only had to edit Config.h and all is good.
...
I was also going to recommend PET. I have used the PET+ from MadeSolid and that stuff is nice. I have printed the Phlask model out of PET+ and you could stand on it. The thing would not break. Once...
I would perform PID tuning/calibration.
Be sure you have the correct thermistor selected for the E3D (1 I belive) and then run the following command from Pronterface:
This will run the...
I hope not. I get much better looking prints at 0.2mm on my Mendel90. Still struggling to get as good looking prints with the new i3v. I have not lost hope however. From what this thing is made...