Most 3D printers (including all of ours) have the Z-axis limit switch at Z-min, meaning when the bed hits the switch the nozzle is in contact with the bed. The Z-axis travel range then tells the...
Type: Posts; User: Access3Dservices
Most 3D printers (including all of ours) have the Z-axis limit switch at Z-min, meaning when the bed hits the switch the nozzle is in contact with the bed. The Z-axis travel range then tells the...
I'm the Operations Director at a nonprofit that provides free services to people with disabilities. In response to repeated cuts to our State funding my boss proposed we start a 3D printing, 3D...
When you moved the endstop down did you increase the Z-axis maximum travel length? If not that would explain the printing above the bed, the bed can't reach the nozzle because it's outside the...
With the older Flashforge firmware you can heat up to 260, but there's also custom builds that go higher. We've had great results printing Polycarbonate at 260, just don't try to push speeds too...
We have two Flashforge Dreamers, they are fairly small volume but can print up to 240°C stock with a heated bed and fully enclosed. Equipped with WiFi and dual extruders, we paid $1k/ea two years...
I'm about to start my first build, Hypercube Evolution with a 400mm x 400mm x 400mm build volume, BOM of cheap Chinese parts was $625 shipped plus about a spool worth of PETG printed parts required...
Today I went into the Repetier Online Configuration Tool to grab the necessary values to change in EEPROM when I noticed I was using the tool version 0.91 but 0.92 was installed on the machine...
We recently upgraded our two Flashforge Dreamers with Micro Swiss All Metal Hotends and have been getting great results from it, even printing in Polycarbonate with the tiny 0.2mm nozzles! We've...
I'm not at the computer which had the compiling issue but I copied the settings from the firmware provided by Cultivate3D into the Repetier Online Firmware Configuration Tool then changed the number...
Hello everyone! An engineer friend of our organization recently finished building us a Cultivate3D Beast which is a large volume FDM printer. Our Engineer built it according to the manual which...
Hello Jerry and welcome to the forum from a fellow newcomer!
-Joe, Access 3D Services
Hello everyone, just a quick update regarding the Increasing Independence for People with Disabilities 3D Design Contest sponsored by Access 3D Services:
Our Board of Directors has decided to...
10400
Access 3D Services is hosting an Increasing Independence for People with Disabilities 3D Design Contest from April 1, 2017 to May 31, 2017. All designs must be the original idea of the...
10397
Access 3D Services is hosting an Increasing Independence for People with Disabilities 3D Design Contest from April 1, 2017 to May 31, 2017. All designs must be the original idea of the...