airscapes
Engineer

Had never heard of such a thing but a quick google shows what it looks like.. This type of object would not print very well. ALL open spaces would...

I have one of these, just cut most of the trays so 2 rolls of filament can fit inside...

Glad you got a print done! Things like this are why the higher end printers cost more.. Tight tolerances, well built assemblies that do not change...

Ok, so cleaning filament is just that. When you remove the pla you heat the nozzle with the nozzle way above the bed and you extrude 200 or 300 mm. ...

and what happens when the print starts.. filament balls up or just does not stick? Have you run cleaning filament through your hot end after the PLA...

PETG sticks to anything if the starting Z axis offset (gap between nozzle and bed when it is at Z0 is within the proper parameters. I use to print...