Close



Results 1 to 3 of 3
  1. #1

    Post Printing 700 micron wide using Ultimaker 2 plus extended

    Hello everyone,
    I was trying to 3D print a cylinder which is 700 microns wide using Ultimaker 2 plus, but couldn't do it. Can anyone just tell me If they tried something similar before? if so did you make any changes in the setting of slic3r? it would be a great help if I could get any suggestions. TIA.

  2. #2
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    5,210
    you'll probably need to change to a nozzle with a smaller diameter. 0.2mm should work.

  3. #3
    Technician Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    62
    Add Roberts_Clif on Thingiverse
    700 microns = 0.7mm

    If you are lucky and printed with a .15 High-Resolution Nozzle layer height of 0.06 - 0.08mm speed at 16-20mm-S you may print a .7mm cylinder.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •