Subscribe to Our Newsletter Advertise
Close



Results 1 to 1 of 1
  1. 05-09-2015, 11:27 PM #1
    hedgehog
    hedgehog is offline
    Student
    Join Date
    May 2015
    Posts
    1

    Printing Problem with Polyethylene

    Hi,

    I encountered a problem while printing with PE filament. The melted PE won't adhere to the bed (heated, with masking tape on top). Also tried perforated FR-4 board, but no luck. I was wondering if anyone could suggest a material which has better adhesion to melted PE. Thank you.


    Henry
    Last edited by hedgehog; 05-09-2015 at 11:35 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules