Subscribe to Our Newsletter Advertise
Close



Results 1 to 2 of 2
  1. 02-17-2015, 09:01 AM #1
    Davo
    Davo is offline
    Staff Engineer Davo's Avatar
    Join Date
    Nov 2013
    Location
    Atlanta, GA
    Posts
    1,085
    Follow Davo On Twitter Add Davo on Facebook Add Davo on Google+ Add Davo on Shapeways Add Davo on Thingiverse

    Hyrel 3D Laser - Test Print - Circuit Board

    A quick test of the Shark5 5w Laser head being used to burn off the soldier mask on a circuit board for direct-write etching.


    Reply With Quote Reply With Quote
  2. 02-17-2015, 04:43 PM #2
    Davo
    Davo is offline
    Staff Engineer Davo's Avatar
    Join Date
    Nov 2013
    Location
    Atlanta, GA
    Posts
    1,085
    Follow Davo On Twitter Add Davo on Facebook Add Davo on Google+ Add Davo on Shapeways Add Davo on Thingiverse
    So, we did that board at 25mm/sec, and there was some wobble. Here are the pics - we'll do the next test at a slower speed and see how it comes out.

    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules