Close



Search:

Type: Posts; User: Turkey

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    842

    Those are all fantastic thoughts. Thank you very...

    Those are all fantastic thoughts. Thank you very much. I will be taking my extruder apart to make sure everything is good. A quick question though. I have a creator pro clone as far as mechanics so...
  2. Replies
    6
    Views
    842

    I can see that being possible. Usually print at...

    I can see that being possible. Usually print at 50mm/sec at 230. But it only does it at the very beginning of the purge line and then goes fine from there. Would slow speed and low temps cause that?...
  3. Replies
    6
    Views
    842

    Purge line trying to jam at beginning?

    So when printing with abs the purge line at the very beginning will skip. I can hear what I assume is the extruder drive gear clicking and the purge line is dashed like is extrudes then jams then...
  4. Well I definitely just archived that post to my...

    Well I definitely just archived that post to my computer. So much useful information there! Thank you! :) I am running similar specs to you it would seem. The printer came with kapton tape adhered...
  5. I wanted to say thank you again for your help...

    I wanted to say thank you again for your help with this first off. I ended up doing a 1 perimeter cube 20x20, setting the multiplier to 1 and the width to .4mm as suggested on 3dhubs. The thickness...
  6. Actually scratch that I used a better set of...

    Actually scratch that I used a better set of calipers and the average is actually 1.73mm. Confused as to why I would need to increase the flow so much if the filament isn't very thin. Any ideas?
  7. Thank you again for quick replies! I just...

    Thank you again for quick replies! I just measured my inland pla I bought as a starter roll and sure enough it is averaging like 1.69 or 68. Please forgive my ignorance but as far as the cube...
  8. Doesn't the dreamer read .x3g? The ultra reads g...

    Doesn't the dreamer read .x3g? The ultra reads g code which is why as far as I know flash print is not an option since it exports only .x3g files. The creator pro I run at work uses flash print and...
  9. Mr aardvark, Thanks for the quick reply and I...

    Mr aardvark,
    Thanks for the quick reply and I have to admit I was hoping I would get your attention. During my research I noticed you seemed to be a very good source of info for this printer so I'm...
  10. Powerspec Ultra Stringing issue/Software advice

    Ok so first off I need to say I have been obsessively researching and learning about fdm 3d printing since I began doing product design and prototyping at my job. My boss bought a Flashforge Creator...
Results 1 to 10 of 10