Care to share that toggle code? I am not sure where to start with writing that, but it strikes me that it would be incredibly useful!
Type: Posts; User: kfahn
Care to share that toggle code? I am not sure where to start with writing that, but it strikes me that it would be incredibly useful!
Has anyone had issues with their hexagon hot ends being different lengths? I ordered two new ones from Makerfarm, and they are ~0.5mm diffferent in length from end to end. There also seems to be a...
That is a good point. I will reference this thread on the dual extruder thread so that clough42 sees it. I will also make sure to check back in here once I hear back from Makerfarm on the new design.
Thanks to everyone for the responses.
printbus: I have a new picture that shows the set screws (or what seem to be set screws) on the actual heatsink. The hexagon has had a definite tweak with...
So I am in the process of putting together clough42's dual extruder so I ordered two hexagon hot ends. Unfortunately the two that I received are different lengths from the heat sink to the heater...
There are a couple of possibilities:
* One way that this can happen is if there was a sudden thick spot in your filament. If the diameter of the filament varies too far, it can jam on the way into...
It is possible to run some hot ends without a cooling fan (j-head and some others), but the hexagon and other all metal hot ends require a cooling fan above the heated tip, but below the extruder...
I can also vouch for that end-stop design. I printed that out on day two (unfortunately with some shrinkage in the back since I didn't have the new shroud yet). I'll have to print it again, but it...
Just to add my 2 cents, I was also having a lot of trouble with my ABS prints curling on my 10" i3v, but I have found a complete solution (for me). I changed the cooling shroud for my hexagon hot end...