Subscribe to Our Newsletter Advertise
Close



Dig deeper, search our News website




Search:

Tag: hictop

Search: Search took 0.00 seconds.

  1. Best Cheap Control Board for Dual X, Dual E, and Dual Z And Config Help

    Started by malachitelab, 05-06-2020 04:23 PM
    board, control board, dual_x_carriage, firmware, hictop 1 Attachment(s)
    • Replies: 9
    • Views: 5,686
    Last Post: 05-15-2020 06:18 AM
    by curious aardvark  Go to last post

    Forum:
    3D Printer Parts, Filament & Materials

  2. another..HicTop Prusia i3 BLTOUCH issue

    Started by whatupcuzz84, 06-08-2018 01:16 PM
    bltouch, hictop, marlin, mpx, prusa
    • Replies: 0
    • Views: 4,060
    Last Post: 06-08-2018 01:16 PM
    by whatupcuzz84  Go to last post

    Forum:
    Tips, Tricks and Tech Help

  3. Warm bed autopid tune numbers are very high compared to examples on marlin firmware

    Started by Warmaster, 03-03-2017 05:34 PM
    autolevel, firmware, hictop, pid tuning, upgrading
    • Replies: 2
    • Views: 4,262
    Last Post: 08-30-2017 05:46 AM
    by Roberts_Clif  Go to last post

    Forum:
    3D Printers (Hardware)

  4. Hictop prusa i3 Z height issue after Firmware Flash due to Auto Level kit install

    Started by DarthViking3DPrinting, 12-29-2016 05:22 PM
    auto level, hictop, prusa i3, z height issues
    • Replies: 7
    • Views: 9,403
    Last Post: 12-30-2016 06:33 PM
    by printbus  Go to last post

    Forum:
    3D Printers (Hardware)

  5. HICTOP prusa i3 Assembly

    Started by dineshwong, 09-29-2015 09:45 AM
    hic, hictop, prusa i3
    • Replies: 0
    • Views: 3,385
    Last Post: 09-29-2015 09:45 AM
    by dineshwong  Go to last post

    Forum:
    3D Printers (Hardware)

  6. Extruder not feeding

    Started by pgriffy, 08-11-2015 03:12 PM
    controller, electronics, extruder, hictop, motor 1 Attachment(s)
    • Replies: 3
    • Views: 9,156
    Last Post: 08-16-2015 07:41 AM
    by printbus  Go to last post

    Forum:
    Tips, Tricks and Tech Help

Results 1 to 6 of 6