Bottom Curling

[bryson0729]

IMG_0001_2.jpg

I've had my Creator Pro for a couple of days now ad have run across the same problem multiple times with my raft morphing, melting, or curling. I have played around with the build plate temperatures and even replaced the Kapton Tape but I'm still encountering problems.

IMG_0002_2.jpg

[stevekr2]

IMG_0001_2.jpg

I've had my Creator Pro for a couple of days now ad have run across the same problem multiple times with my raft morphing, melting, or curling. I have played around with the build plate temperatures and even replaced the Kapton Tape but I'm still encountering problems.

IMG_0002_2.jpg

120 !! That's too high for ABS and off the charts for PLA . 110 to 112 for ABS.
Recommend you read Geoff's sticky at start of forum.
With thanks.....

[Geoff]

120 !! That's too high for ABS and off the charts for PLA . 110 to 112 for ABS.
Recommend you read Geoff's sticky at start of forum.
With thanks.....

Ditto 120c is the issue, way too hot. If you can't get it to stick using lower temperatures use a glue stick and some blue tape.