Has anyone had any success printing in wood filament

[patreojames]

I bought a roll of wood filament from colorfabb and started to print, however the nozzle keep getting blocked with the extruded wood filament. I am using 1.75mm on a solidoodle 2. I just can't seem to print a successful object. Has anyone had any experience with this new material?

Thanks

[richardphat]

What is the diameter of your nozzle ?

[Davo]

We print LayWoo-D3 fine through a .5mm nozzle.

[curious aardvark]

printed laywood through a 0.4mm nozzle on my flashforge at 200c - no noticeable issues.
Prints nicely, doesn't warp, sticks to blue tape without glueing itself like pla can.

No actual problems. That doesn't help you I realise.
What temp were you printing at ?

[joealarson]

Printing, no problems. Storing, however, was a different issue. Stuff snaps like twigs.