Results 1 to 7 of 7
Thread: Bad CRC received
-
11-16-2014, 08:23 PM #1
- Join Date
- Nov 2014
- Posts
- 4
Bad CRC received
What causes 'bad crc recieved' and how does one recover from it in mid print?
-
11-17-2014, 06:59 AM #2
Unless just the right person reads this, you'll have to mention what device you are using and when this occurs.
-
11-17-2014, 01:54 PM #3
- Join Date
- Nov 2014
- Posts
- 4
Thanks. Am using a Creator Pro with ReplicatorG -0040 and the lock up is any random print at some random point mid print. I can discern no pattern in the stop point. Ernie
Last edited by Ernie; 11-17-2014 at 02:03 PM.
-
11-17-2014, 01:57 PM #4
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
SD card corrupt, try another one.
-
11-17-2014, 02:16 PM #5
- Join Date
- Nov 2014
- Posts
- 4
Tried and still have same problem. Also does on usb port to computer.
-
11-17-2014, 02:49 PM #6
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
In that case the next thing is a possible knackered power supply. If that doesn't cure it then you're in for a new motherboard.
-
11-17-2014, 04:28 PM #7
- Join Date
- Nov 2014
- Posts
- 4
Thank you much for your time and advice. Will post result if any. Ern
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion