Results 1 to 3 of 3
Hybrid View
-
10-26-2014, 10:33 PM #1
Heated build plate not holding temp
I just upgraded my Replicator 2 to have a heated build plate. When I run any model after preheating the HBP just starts dropping and will not keep any heat.
I upgraded to sailfish and still have the same problem.
Should I change my makerware profile to Replicator 2x so I can set the plate to on or is there something else that needs done.
thank you
-
10-28-2014, 02:09 PM #2
-
10-29-2014, 02:09 AM #3
Well done! Welcome to Problem Solving for 3D Printers 101.
There are no major problems. Most times the answer is hiding somewhere.
Old Man Emu
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion