Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3

Thread: Heat bed relay

  1. 10-05-2014, 03:37 PM #1
    DanB
    DanB is offline
    Student
    Join Date
    May 2014
    Posts
    11

    Heat bed relay

    Hi guys, I have an 8" prusa i3v and I'm trying to install a heat bed relay. Does anyone know which wires from my antec power supply to plug into the relay? There were no instructions on this that I could find on the makerfarm website.
    Reply With Quote Reply With Quote
  2. 10-05-2014, 05:14 PM #2
    eghm
    eghm is offline
    Student eghm's Avatar
    Join Date
    Apr 2014
    Posts
    29
    I haven't installed one, but it is in i3v RAMPS Install http://www.youtube.com/watch?v=ieBwDM1qxAA 12V
    Reply With Quote Reply With Quote
  3. 10-05-2014, 05:40 PM #3
    printbus
    printbus is offline
    Staff Engineer printbus's Avatar
    Join Date
    May 2014
    Location
    Highlands Ranch, Colorado USA
    Posts
    1,437
    Add printbus on Thingiverse
    The +12v outputs from the power supply are usually yellow (+12) and black (return) wires. So, if you have another connector with yellow and black wires, run those to the heat bed relay.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules