Starts well, ends terribly

[Albertoinbox]

Printing cable clips, looks good in the beginning but as it gets higher it goes from bad to worse, whats going on? Thanks.

[Bikeracer2020]

Just a suggestion.........

Check your extruder 'e' steps and try ORCA slicer, it has some built in calibration files that you just have to print.

[Albertoinbox]

Unfortunately my printer isnt listed in Orca.

[Bikeracer2020]

Which printer are you using?

[Albertoinbox]

Flashforge Guider 2

[Bikeracer2020]

Perhaps manually transfer the settings from your current slicer into ORCA slicer as a start. bit tedious, but one way to make your own slicer profile.

Also look on YouTube for over and under extrusion problem videos

[Albertoinbox]

Thanks for the help