hi all.I have an Ender 3 s1 Pro running a Sonic Pad with Klipper firmware.When I send a print job which is wide and flat it doesn't print well without a raft. With no bed adhesion or with a skirt or brim I get nozzle dragging, lumps and bumps and general bad results.If I print the same design on a raft it comes out perfect.I do manual tramming at temp (60 degree bed and 200 nozzle) with a 0.1mm feeler gauge before a 100 point auto bed levelling. Standard settings in Cura with only the addition of a raft.Creality PLA filament, just opened.what's going wrong?