Hello all. I have not seen any thread with similar problems or that solves my problems, if there is something, link it to me in case I have missed it. After installing sprite pro and crtouch, with the firmware Ender3V2-422-BLTUBL-T13-MPC-20230524, and the dacai for the screen, I can’t level the bed in any way (I changed the wheels) In addition to not leveling, I am touching the probe settings, now when doing bed tramming front/back left/right, the nozzle and crtouch stays inside the bed, but it seems that the virtual position of the bed has moved to the left, also , that if I start to print, it does so in the front left corner. I also have a cable labeled E left over in the same set of cables that goes to the X motor, I think it is left over but I’m not sure. Any ideas? Thank you.