Results 1 to 4 of 4
  1. #1

    Help! My PLA prints go limp in the sunshine.

    I print a lot of mechanical parts in PLA. I have found when I have them outside they go limp and misshapen when in the sunlight. Is there a filament that solves this problem?
    Last edited by Gloin The Dark; 06-21-2023 at 02:07 PM. Reason: Add a better title.

  2. #2
    ABS, PETG, Nylon.. anything but PLA.. PLA goes limp at about 110F. Do a google search on 3d filament types and read the pros and cons of each material .

  3. #3

  4. #4
    Try pla plus materials, or use more heat-resistant abs instead

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts