Results 1 to 2 of 2
Thread: Roller Wheel Issue?
Threaded View
-
04-08-2023, 01:44 PM #1
- Join Date
- Jan 2023
- Posts
- 6
Roller Wheel Issue?
When I received my Ender 3 S1 and first assembled it I noticed the X and Y motion had what felt like a dead spot in the rollers or the aluminum guide itself. So I adjusted the roller tension which was indeed too tight. The dead spot was now only slightly noticeable, and over time seemed to diminish.
Lately printing in spiral/vase mode I notice at a certain elevation the layers are off like something randomly shifted. I'm printing at a relatively slow 50mm/s, .2mm layer. I notice this defect to varying degrees on similar prints.
Spiral Issue.jpg
I know its tough to quantify but how smooth should the X?Y axis move? Does the rolling resistance need to be perfectly constant or is some deviation OK?
Ender 3 Neo - Jam Problem
Today, 03:06 PM in Tips, Tricks and Tech Help