When I received my Ender 3 S1 and first assembled it I noticed the X and Y motion had what felt like a dead spot in the rollers or the aluminum guide itself. So I adjusted the roller tension which was indeed too tight. The dead spot was now only slightly noticeable, and over time seemed to diminish.

Lately printing in spiral/vase mode I notice at a certain elevation the layers are off like something randomly shifted. I'm printing at a relatively slow 50mm/s, .2mm layer. I notice this defect to varying degrees on similar prints.

Spiral Issue.jpg

I know its tough to quantify but how smooth should the X?Y axis move? Does the rolling resistance need to be perfectly constant or is some deviation OK?