X400 DIY Special offer kit (buildup)

[Luchador]

So,

I already added some profile on the top, the ide is to close the sides later.

I already printed a few parts direkt on the ceramic plate its possible but the plate need to be realy clean if not it can happen that it will lift up from the plate.
bec of my experiance with buildtak i will add a makrolon plate with an buildtak foil.

IMG_8305.jpgIMG_8282.jpgIMG_8291.jpg


My Resümee for this Printer so far, A good Printer the Ground Assambly is easy but need be be made realy good ( quick quick is the wrong way)
The final adjustment is possible alone but with 2 people simple much easier.

The Printing Results so far good (much better than my usual results)

The Printer brings a los of possibilities bec of the profiles and with the milled table its easy to add anything you want ( my next project is a ring fan and than an extruder Holder to change the extruder and also to use different ones)

For this price this printing space in that quality For me it was the right decision.


best regards
Thomas