Close



Results 1 to 1 of 1
  1. #1

    Flashforge Invetor II failure

    I've been asked to look at a Flashforge Inventor ii. I has zero files on internal storage and displays zero available. I did the factory reset and there was no change. The internal storage is still full.
    Aside from that, there are a couple more repeatable failure modes.
    1. Firmware updates via PC software, USB and Wifi all fail with 'network/file failure'.
    2. Sending files to the printer still fails with 'network/file failure.;
    3. Preheat the extruder hits 220C and stops there.
    I've reseated all the connectors on the main board. Is there a secret diagnostic boot sequence? Is there a way to get more information from the printer?
    Thank you.
    Last edited by kkinney; 09-06-2022 at 07:43 PM. Reason: line breaks disappeared

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •