Results 1 to 10 of 17
Thread: What will improve this ?
Threaded View
-
05-08-2022, 01:29 AM #11
- Join Date
- May 2020
- Posts
- 619
It was just drawn in Fusion 360, it's approx 100mm by 140mm.
Just a rectangle with the face drawn on it then extruded up 3mm and exported as an .obj file.
Qidi had similar results using Prusa slicer, no solution as yet and I doubt there will be. In the unlikely event I print that particular file again I'll probably go for concentric pattern rather than lines.
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion