Close



Results 1 to 6 of 6
  1. #1
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,143
    Add Roberts_Clif on Thingiverse

    Hictop controller MPK_V1 pinout mapping

    The pin-out mapping is very similar to the Base v1.3 an MPX.3 they do not have a H6 connector


    You may note : two ICSP ports on controller. H6 is a standard ICSP header, but for programming the ATmega 16U2







    One of my projects is Finished

    MPKv1.jpg
    Last edited by Roberts_Clif; 01-20-2022 at 03:21 PM.

  2. #2
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,787
    lol kind of a random post.
    what's the project ?

  3. #3
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,143
    Add Roberts_Clif on Thingiverse
    Yea kind of.

    Most of the users I have helped with Hictop controllers have asked me many times If I had a Pin-out for the Controller.
    Did not know of a better way of getting this information to them.

    Finally had time so I created a diagram an posted it for all those who asked me for one...

  4. #4
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,787
    controller for what ?

  5. #5
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,143
    Add Roberts_Clif on Thingiverse
    This a Hictop 3D Printer Arduino Mega2560 Ramps compatible single board controller. It is equipped with Dual extruder drivers E0 and E1.
    I find they last a long time it you use TO-220 transistor kits with a bar heat sink.

    Controller 2.jpg

    mounting.jpg

  6. #6
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,787
    AHH, cool.Sounds very similar to the boards pruse use for the mk3

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •