Total budget £150

So that's for:
The printerWash and cure box with light powered turntable.
Some resin.

At the moment I'm looking at a few machines on AliExpress, there's three or four that come in just under £100.
And a couple just over.

A big old 495nm spotlight with a UV powered turntable, comes in at around £25.
Shove that in a foil lined box, sit a mason jar with isopropyl on the turntable and jobs a good 'un :-)

And some tough resin from AliExpress at about £15 for 500g
I also fancy some transparent resin as well.
I've seen some printed lenses, looks like fun :-)

Not a clue where I'm going to put it. Space will be made, somewhere.

I've got a few ultra fine detail designs that fdm simply won't pull off.
Plus the price points for machine and resins has finally become sensible for someone with very little money :-)

The new cheap tough resin, cures up like moulded abs, but stays flexible for easy support removal until final curing.
Which sounds like it'll do most jobs.

Machine wise, it's surprising how varied the sub £100 machines are.
The worst seems to be the creality one, minimum layer 0.078 layer height.
A slightly cheaper one had a 0.025 minimum layer height.
Which should do the job.

Then you've got print speeds from 20mm an hour max speed on up to 60mm an hour.

So a bit more research is in order.

But I reckon £150 should do it.

Watch this space :-)