All of a sudden my prints stick to the nozzle of my ender 3 pro. I think it's because the nozzle is too high, but i made sure it was leveled perfectly using the auto home. Even the long line the printer draws before starting when using cura sticks to the bed, unlike the actual print. If i adjust my z offset an insane amount to get it closer, the print peels and looks awful. I'm not sure what's going on.

Video: https://photos.app.goo.gl/Xt9eJ2Fw7rtbStZ28Filament

peeling on bed: https://cdn.discordapp.com/attachmen...83.jpgFilament

stuck to printer: https://cdn.discordapp.com/attachmen...417763.jpgJust in case i

put my Inland PLA in a heater box for 4 hours, just in case moisture had anything to do with it.