Results 1 to 5 of 5
Thread: Zapojen?* BTT Octopus V1.1
-
09-18-2021, 07:19 AM #1
- Join Date
- Mar 2021
- Posts
- 62
Zapojen?* BTT Octopus V1.1
Hi.Please try to connect the BTT Octopus V1.1 board to the Ender 5 Plus and I don't know how to connect it (photos).https://cdn-3d.niceshops.com/upload/...Octopus_EN.pdf
-
09-18-2021, 09:49 AM #2
Hello. That part looks like the bed heater's MOSFET. The 2 small red and black wires will go to the Octopus' hotbed output. The big wires connected to the screws from left to right should be voltage in(+), voltage out(+) to bed, and ground(-).
-
09-18-2021, 12:35 PM #3
- Join Date
- Mar 2021
- Posts
- 62
Hi.
Please, I don't understand the translation very well (English is not my native language). Just for example, Weak cables are connected to the + and - board. That MOSFET is connected to the source from left to right 1 (+) red and 3 (-) black wires are connected to the source. The middle 2 (-) wire is connected to the bed and the (+) red bed is connected to the source.
It should be like this? Thank you for your help.mosfed.jpg
-
09-18-2021, 12:57 PM #4
-
09-18-2021, 02:27 PM #5
- Join Date
- Mar 2021
- Posts
- 62
Thank you for the great help.
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery