PETG Filament Printing Issues

[Slabbert]

Hi All,

New to the forum.

I recently bought Cron PETG Filament. I have been printing with PLA with a lot of success.
It's giving me a lot of issues. It prints the first 20-50% of the part, depending what the part size is and then the nozzle clogs...
I attached a pic of the Benchy I tried printing

Can someone please assist?

My Setup
Wanhao D9 Gen 3 with Direct Drive, E3D Volcano Hot end

My Print Settings
0.4 Nozzle(I have tried bigger nozzles, same issue)
Layer Height 0.2mm
Initial Layer Height 0.3mm
Wall Thickness 0.8mm
Top/Bottom 0.6
Printing Temp 235(Have tried up to 250, same issue)
Build Plate Temp 70
Retraction 2mm(Is a direct drive)
Retraction Speed 30mm/s
Print Speed 40mm/s
Top/Bottom Speed 20mm/s
Cooling 50%

Thanks