Results 1 to 10 of 20
Thread: Garolite Mounting Question
Threaded View
-
06-24-2021, 09:38 AM #11
- Join Date
- May 2018
- Posts
- 561
Yes it leaves a line, but with water floating the tape in place it can be rather thin.. it is 3d printed.. whats another line.. it is nothing but lines ;-)
Yes I have printed on just glass with glue but warping is always the issue.. an enclosure with heat also helps with the warping. This mount almost sounds like you should be using aluminum.. just have it made and save a lot of time, hassle and maybe money trying to use Nylon, which I am going to bet you will not be happy with the end result, especially if it is a one off part.. sometimes just because you can do something, does not mean you should. Rather than just diving into the deep end, buy a roll of standard 910 and print some parts on glass and see how things go.. you can always try new bed surfaces..
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion