Hi everyone,

I'm not usually one to jump on forums, this is actually the second forum I've ever used! I've been having so many issues over the years getting my P3Steel to work and I figure it's time to reach out for help.

The issues I'm experiencing:

- Squished prints, z axis is calibrated
- Nozzle oozing
- Constant leveling issues, seems to change every 5 mins
- Getting mixing nozzle to work (Cyclops)
- z axis drifting ( one side of x axis higher than other) randomly

I've been struggling with it for years. Normally I'm good with troubleshooting but this has me losing my mind. Any help or guidance would be much appreciated!

Current setup:
- P3Steel form factor
- Cyclops Original Hotend
- Rambo Board
- 24v bed and hotend
- Currently using Marlin Firmware, Repetier Host and Slic3r
Eventually want to change to PrusaSlic3r in future