Close



Results 1 to 3 of 3
  1. #1

    Calibration Problem Need Help.

    Dear Forum Members

    I build a corexy 3d printer and i have a problem when test calibration prints.

    Any one can help me, what problem with my prints ?

    20210228_105556.jpg20210228_105607.jpg

  2. #2
    Staff Engineer
    Join Date
    Jul 2016
    Location
    South Florida, USA
    Posts
    1,018
    Add AutoWiz on Facebook
    I have a couple thoughts on that. First try printing it 5c cooler. Then again 5c cooler. And again until it wont print well and understand the best temp to melt that specific roll of filament. Or just go print out the temp tower. But I think it might print better at a slightly lower temp. I also think You can enable linear advance in marlin and then tune it so you maintain the right pressure in the nozzle. If your problem persists past that you can look to acceleration and jerk/ junction deviation settings.

  3. #3

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •