Results 1 to 1 of 1
-
02-03-2021, 10:40 AM #1
- Join Date
- Feb 2014
- Location
- Tyler, TX
- Posts
- 18
Lost in the SW maze (Cura, Slic3r, Pronterface, MatterControl etc.
I am trying to figure out a combination of printer control software and slicer that is up-to-date with current features.
I think something like Pronterface and Cura might be a good combination or Pronterface and prusaslicer but don't know how to integrate the two of them.
I have used MatterControl 1.7 for years with the MatterSlicer but it no longer has updated features. They have a newer version (2.x) but somehow they messed up the interface and it is hugely awkward.
So far, I like the human interface on Pronterface and I read good things about cura and prusaslicer.
Are either of those a good match?
If so, how to integrate the them?
Alternatives???Last edited by PickyBiker; 02-03-2021 at 01:25 PM.
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion