Hi All I'm hoping someone can put me on the right track.I have an Ender 5s which I recently started using and reading about. There was all sorts of "you should upgrade" comments. so I upgraded the bowden tube, and bought a glass bed, some TL Smothers, 4.2.7 silent board, and a BL Touch.I have questions The Glass Bed - What temperature does everyone run with, I'm struggling to get prints to stickTL Smoothers - I installed them, BUT with the new 4.2.7 board should I remove them ? the BL Touch and new board. Since I put those in I cannot get the unit to home. Depending on the firmware, it either just beeeeeeeeeps when I turn it on, or goes to Printer FAULT when I try to home it, or moves a bit and then says Stopped on the display.I've tried all sorts of different versions of firmware. Does anyone know what one I should be using, or what I'm doing wrong ? Any help would be greatly appreciated!Thanks !