Hi
I am new at this, and hope someone can please advise. I am a hobbyist (dioramas), and do not design 3D models.

I have Creality LD002R printer and havebeen able to print some stuff. (yes, including the Eiffel tower ;-))
When I try to print something that has spokes, they do not print. I have tried this is 1/35 scale, and also in 1/24th scale.

I use the default settings which are:
  • Layer Height : 0.05mm
  • Bottom Layer count: 10
  • Exposure time : 9s
  • Bottom exposure time: 50s
  • Light-off delay: 0s
  • Bottom light off delay: 0s
  • Bottom lift distance: 5mm
  • Lifting distance: 5mm
  • Bottom lift speed: 65mm/min
  • Lifting speed: 65mm/min
  • Retract speed: 150mm/min.


Further to this, I have tried supporting and without supports.

Please help?
Thanks
Richard