Hi all,

I have just about finished assembling a Two Trees Sapphire Plus printer. While the assembly instructions were almost useful (well, okay, they weren't really useful), there are no instructions at all on how to operate the printer. This is my first excursion in the land of 3d printing. Their tech support folks have been as helpful as they can be, but the time change means, at best, one email per day.

Are there any standard instructions that might be related to the firmware used, or the general construction of this printer, etc. that I could reference? Happy to do the homework, just not sure where to start.

Thanks for any guidance you might be able to provide.

Ron