Results 1 to 8 of 8
Thread: New here Anet-8 question
Threaded View
-
11-08-2020, 07:44 PM #1
- Join Date
- Nov 2020
- Posts
- 4
New here Anet-8 question
Hello i am a newbie here and to 3d printing, i just bought a Anet-8 off amazon for 135, i know its not the top of the line but i just wanted something to get my feet wet in this world. I printed my first project which was a baby goot flower pot came out pretty nice, but it was only 4 inches tall. i have been unsuccessful since. i notice when my printer starts the pla is ok at first then starts piling up in certain spots and then just comes off. is there anything i can do to fix it or itll get better as print goes on? any help i would appreciate it thanks in advice. - Raymond
Ender 3 Neo - Jam Problem
Today, 12:39 PM in Tips, Tricks and Tech Help