Results 1 to 1 of 1
Thread: Z Banding problem
-
11-14-2020, 10:16 AM #1
- Join Date
- Nov 2020
- Posts
- 1
Z Banding problem
Hi All Printer: DIY CoreXY SKR1.4 main board TMC2209 Drivers XY 64step Z 32stepE0-E1 32step Z Screws M8 2mm pitch 4 Start same problem with M8 2mm pitch signal start. nozzle 0.4 volcano block. I am having a problem with horizontal lines on my prints. It's not z wable. It's more like thick then thin then back to thick. The cube is 25x25x10 – 25.04 x 24.79x 9.7 1.20 thick. Any help would be appreciated. Thank You
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion