Results 1 to 2 of 2
Thread: Thermal Runaway E1
Threaded View
-
10-12-2020, 03:02 AM #1
- Join Date
- Oct 2020
- Posts
- 13
Thermal Runaway E1
I am currently building a Hypercube Evolution from a kit that was passed on to me. It uses a BIQU KFB2.0 control board and a 24 volt power supply. I have no prior experience in 3D printing.
I was getting to the end of the build. Everything was working. I was testing every component as I added it using Pronterface. I have not covered the aluminium heated bed with anything as I did not want to cause problems for the the induction sensor (used as Z Min endstop). The induction sensor has a 4mm range for ferrous metal and less for aluminium. I was intending to print on blue tape.
One website I visited suggested using feeler gauges as a better choice when levelling the bed. So I did. What I did not know is that both the hotend and the bed have power running to the outer surface. I found out when a feeler gauge touched the bed and the hotend at the same time. Since then, my LCD display gives the message "Thermal Runaway E1 press reset". I have pressed reset on the control board to no avail. Short press, long (5 and 10 seconds) and double press. None of which work. I have disconnected the hotend and it's thermistor from the control board. I have tried using another thermistor, but to no avail. Pronterface, when trying to connect, gives the following two lines:
"Error: Thermal Runaway, system stopped! Heater_ID: 0
Error: Printer halted, kill() called!"
I have also re-compiled Marlin 2.0.6.1 using Auto Build Marlin and uploaded to the board, still the error persists. Anybody any idea how to fix this problem?
Please explain to me how to...
05-13-2024, 03:08 PM in 3D Printer Parts, Filament & Materials