Results 1 to 2 of 2
Thread: Good adhesion except one corner
-
10-02-2020, 08:04 PM #1
- Join Date
- Aug 2020
- Posts
- 3
Good adhesion except one corner
Hello
I have an Ender 3 Pro and i recently managed to ram my hotend into the printbed while trying to calibrate my bltouch z offset.
since then in the lower left corner nothing wants to stick to the bed anymore.
I have also switched around the buildplate but its still the same problem
P_20201002_210708.jpg
P_20201001_212247.jpg
-
10-04-2020, 10:31 AM #2
- Join Date
- Sep 2020
- Posts
- 4
You are still printing too high, so further adjustment of Z offset is needed. Graphic for reference:
first_layer-768x433.jpg
If you still have curling in the corner, after perfecting first layer, then collision might have done some damage - could be either BLTouch or mechanics of the printer (axis alignment, X/Y carriage, bed surface, etc)
Then i would have few additional questions:
Can you do probe repeatability test?
Do you have enabled ABL? Did specified compensation (settings or gcode)?
Is extruder carriage (x axis) perpendicular to bed (y axis)?
Ender 3 Neo - Jam Problem
Yesterday, 03:06 PM in Tips, Tricks and Tech Help