I purchased the BLtouch sensor, SKR mini e3 v1.2 and the TFT35 v3 touch display. I have everything installed. I have printed successfully on it, but I leveled it by hand the first print. I have probed the board and stores it. I set the z off set. When I print though it does not use the bltouch. I was unable to compile the firmware because I keep getting errors in vs code about squiggles and include errors so I gave up and used precompiled firmware.

I do not have the zstop plugged in and plugged the bltouch into the zstop as recommended. Can anyone please help me get this to work? What the hell am I missing.

I am not sure what information anyone will need to help me just let me know and I will pull it. God I hope someone knows wtf is up with this.