hey.

i noticed that my printer wasent properly calibrated for a week ago when i tried to print out things that should get into each other.
i have been done some calibration on my makerfarm printer. i tested to print a cube that is 20x20x20 mm

it came out 22x22x20 mm,

i have set up the wall thickness to 2 lines and they are about .5 wide.

is it so that the printer prints the walls outside the modell or is it the steppers that need to be calibrated.

is the printer adding the outlines on the inaede or outside of the modell? or can i change it in slicer to make to software to generate the walls on the inner side of the modell.

wall (2 lines/.5) + modell (20 mm) + wall (2 lines/.5) = 22 mm

is i thinking right now?

my setup

material: abs
nozzle: .5
ex multiplier: .9
extruder steps 904
ex temp: 225
bed temp: 60 (using fleks3d printbed)
x stepper: .43.9 mV
y stepper: .44.3 mV
z stepper: .44.0 mV
e stepper: .44.3 mv


any advice?