Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 08-23-2020, 12:11 PM #1
    ShotgunShane
    ShotgunShane is offline
    Student
    Join Date
    Aug 2020
    Posts
    6

    Filament build up on nozzle

    during long prints filament has been building up in giant balls, sometimes pulling the piece off the bed. Any advice on how to fix this?
    Reply With Quote Reply With Quote
  2. 08-24-2020, 03:55 PM #2
    Azurl
    Azurl is offline
    Student
    Join Date
    May 2020
    Posts
    13
    could be one of two things in my experience, over extrusion because of wrong calibration of the filament extruder. or, the nozzle isn't screwed on tight enough.
    Reply With Quote Reply With Quote
  3. 08-25-2020, 02:15 PM #3
    ShotgunShane
    ShotgunShane is offline
    Student
    Join Date
    Aug 2020
    Posts
    6
    Quote Originally Posted by Azurl View Post
    could be one of two things in my experience, over extrusion because of wrong calibration of the filament extruder. or, the nozzle isn't screwed on tight enough.
    I think you're correct. Can I just wipe it off and tighten the nozzle?
    Attached Images Attached Images
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules