Horrible Stepper motor grinding when auto bed level is enabled

[Butt_blaster]

Printer: Ender 3 pro, basically nothing is stock. Of note I just upgraded the mobo to an skr mini e3 2.0 and flashed marlin 2.0.6, Bltouch bed leveler

Hello, my ender 3 grinds horribly when auto bed leveling is enabled. Without abl on the print runs fine, that is to say the device is still installed but the printer isn't leveling.

SOUND WARNING/PRINTER GORE:https://drive.google.com/file/d/1VBpqicMJaAlgbCBVnjg5iH2Qd4vYWnO6/view?usp=sharing

As far as I can tell, x,y, and e motors are skipping/grinding though it seems most severe on x. Z seems happy, but it moves so slightly that its hard to tell.I tried this with the stock board and the firmware creality gives you for the bl touch, then the th3d unified firmware when that failed, then I upgraded to the skr mini & marlin when that failed, now I'm getting ready to print a nice big THOR HAMMER TO STORM CREALITY HQ.

Belt wells are clean, belts are tight but not stupid tight, I've been testing several mm off the bed so no nozzle crashing. Again, no problems when printing without auto leveling.

The only common thread at this point seems to be the gcode, attached is that as well as my cura profile. I feel like it's either that or z motor grounding? No idea at this point honestly.

gcode: https://drive.google.com/file/d/1ll7D7AqnZ1x0qiGvrGGkfYU91M4qWNFr/view?usp=sharing


profile: :https://drive.google.com/file/d/1FHptWbnlLew63jkuXkjPA8v2icm6pVci/view?usp=sharing

I may be butt_blaster, but I'm getting butt_blasted by the bltouch right now.

Pls help,Blaster