IMG_20200902_232810.jpgIMG_20200902_232758.jpgIMG_20200902_232901.jpgIMG_20200902_232930.jpg

Got it installed, took some 4+ hours of hw assembly and couple hours or so final calibration. Printed example gcode that ships with the driver package, worked fine after some initial issues. Haven't sliced anything yet, probably tomorrow.
Haven't built the filament buffer yet, have to find a proper spot for the printer now that it and all the filament takes more room.

AutoWiz, had similar issue I recall you had when feeding the filament to the extruder, it just kept feeding and created a blob. That was due to the extruder filament sensor not detecting the filament, had to adjust it properly. At least with Prusa printer the extruder filament sensor is required, don't know if that's how it works in the mainline Marlin.