Results 1 to 2 of 2
Thread: large blobs
-
09-30-2020, 07:45 AM #1
- Join Date
- Sep 2020
- Posts
- 3
large blobs
About every 90 minutes I get a really large blob on my prints. Its so large the next pass knocks it off the print and the print turns out ok. It leaves a small burn mark like inside the letter B in the pic. I upgraded the board from cr10 to cr10s and added the creality aluminum extruder. Im using the chepclub profiles. Any ideas how to correct this?
-
10-07-2020, 08:31 AM #2
- Join Date
- Sep 2020
- Posts
- 3
There are tons of questions on this forum with no replies . It had something to do with my hotend so i bought a new hotend for $25 and now its printing fine.
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion